Add products by adding codes
Thermostat 12V W2 -50°C to 110°C - Red-Blue - with temperature controller
- The electronic thermostat is powered by 12V current. It has a temperature control from -50 to 110°C which allows you to control connected external devices. Display shows actual and programmed temperature.
Thermostat 12V W2 -50°C to 110°C - with temperature controller
The electronic thermostat is powered by 12V and works in the temperature range from -50 to 110°C. It has temperature control which allows you to control connected external devices. Display shows actual and programmed temperature.
It can be used to turn on and off apparatuses in your own projects, aquariums, pools, refrigerators, coolers, etc. The waterproof sensor has a cable about 30 cm long.
Programming mode:
Enter the settings by holding down the SET button for about 3 sec. The flashing sign of the upper display indicates that we are in programming mode. Pressing the upper or lower button, you move through the successive programming modes, to enter a particular one, press both buttons at the same time. The same way you save your settings after by clicking both buttons at the same time:
- P0 H/C Operation type heating "H" cooling "C" ( default C )
- P1 is the hysteresis, i.e. the permissible temperature range in which the controller does not take any reaction
- P2 upper limit of allowed temperature possible to set from the panel with up ; down buttons .
- P3 lower limit of allowed temperature possible to set from the panel with up ; down buttons
- P4 Correction ( calibration ) of the temperature sensor ( -15 to + 15 )
- P5 Adjustment of the response time to a change in the set temperature Adjustable from 0 to 10 minutes
- P6 Setting the over-temperature alarm - the buzzer turns on and the characters "HHH" are displayed: ON / OFF by default OFF change to ON and confirm with two buttons and then set the desired alarm temperature.
- P7 Setting the display of °C / F - also when the lower button is held down
- P8 Restore factory settings
The regulator has an alarm for a faulty temperature sensor circuit through which the meter has additional protection. It has a memory of the settings when the power is turned off.
The value of the adjustable temperature can be changed by pressing the SET button for about 2 seconds, when the display starts flashing then use the buttons to change the temperature. After a few seconds of inactivity, the regulator itself returns to standby mode.
Technical data
- measuring range: -50°C to 110°C
- two LED displays: the top one in red (temp. sensor), lower blue (ust. temp.).
- built-in buzzer
- nTC 10K sensor
- ambient temperature: -10°C to 60°C
- measurement accuracy +/- 1.0°C
- power supply: 12V DC
- dimensions: 48 x 29 x 32 mm
- case color: black
- lED display: blue/red
- sensor cable length (waterproof): ~ 30cm
Included
- Thermostat 12V W2 -50°C to 110°C - with temperature controller - 1 piece
- Sensor with cable - 1 piece
