Add products by adding codes
Digital thermostat W1219 - adjustable -50C +110C - module - dual display
- XH-W1219 thermostat with dual digital display (Top display shows current temperature. The bottom display shows the set temperature.). Uncomplicated integrated thermostat module with which we can control the receiver.
Digital Thermostat W1219 - adjustable -50C +110C
Description
W1219 thermostat with dual digital display (Top display shows current temperature. The bottom display shows the set temperature.). Uncomplicated integrated thermostat module with which we can control the receiver up to 2300W.
The module has a detachable NTC waterproof thermistor that measures the temperature.
The process of setting the temperature is very simple, just press the "SET" button - then the display starts flashing and with the + and - buttons you set the desired temperature value.
The module has heating and cooling function: H/C, depending on the selected function, e.g. H, the relay will be on below the set value until it is reached + set, or no hysteresis. However, function C or cooling, the relay will switch on above the set temperature and work until it is reached.
The module remembers the set value even when the power is disconnected.
Technical data
- Supply voltage 12 VDC
- Current consumption 65mA
- Contact load capacity 20A (for 14VDC)
- Contact load capacity 10A (for 230VAC)
- Temperature control range -20 to 100C
- Hysteresis adjustment range 0.1-20C
- Resolution 0.1C
- NTC10k sensor on 30cm cable
- Measurement frequency 2/s
Programming
- MENU - to enter the programming system, hold down the SET button for about 4-5 seconds.
- select programming mode P0 - P6 using the + and - buttons
- enter the selected mode by pressing the SET button
- confirm the selected value with the SET button
Programming modes P0 - P6:
- P0 - selection of C/H cooling or heating
- P1 - hysteresis tripping range selectable from 0.5 to 15°C
- P2 - upper temperature limit (default 110*C) range -45°C to 110°C
- P3 - lower temperature limit (default -50*C) range -50°C to 110°C
- P4 - calibration of the thermometer in the range of -7°C to 7°C (set when temperature readings are erroneous)
- P5 - relay activation delay time in the range of 0min to 10min
- P6 - too high temperature alarm can be set 0 to 110°C
- switching on the + and - buttons at the same time when the supply voltage is switched on resets to the factory settings
Included
- Digital thermostat W1219 - adjustable -50C +110C - module - dual display + waterproof probe - 1 set - 1 pc.
